Hillsound FreeSteps6 Crampons Ice Cleats

SAFETY WARNING:

Hillsound Equipment Inc.\xCDs crampons and traction devices are designed to provide improved traction in snow and ice conditions. This traction device is not suitable for technical ice climbing, steep terrain or mountaineering. Hillsound products do not eliminate the risks associated with snowy and icy conditions and cannot prevent all slips and falls. When wearing Hillsound products, always use caution, extreme care and common sense. Failure to do so could result in injury or death. The user alone is responsible for determining whether his/her experience, combined with the equipment, terrain and weather, present a risk. The user alone assumes responsibility for the safe and proper use of this product and any risk associated with its use. Activities involving the use of this equipment are inherently dangerous. Hillsound is not responsible or liable for any loss, damages, injury or death caused by the use of this or any other Hillsound products.

LIMITED WARRANTY: Hillsound crampons have a 2-year warranty against damage due to poor workmanship and/or defective materials excluding normal wear and tear, oxidation, alterations and modifications, damage by mechanical force, improper storage and maintenance and uses for which this product is not designed. In the event that the Hillsound product does not perform as listed, the user shall notify Hillsound of any such defect within 90 calendar days from the date when the defect was observed. The user\xCDs sole and exclusive remedy shall be limited to the correction of the defect by adjustment, repair, replacement or refund, which shall be at Hillsound\xCDs election.

SAFETY INSPECTION: Before each use, check over the product to ensure there is no damage, such as chains splitting open or tears in the rubber. If damage is found, discontinue use to prevent further damage and potential injury. Please return the product to your local Hillsound retailer. Test product before each use for proper fit. Check positioning of front & rear spikes on the outer sole of your footwear. All spikes must fit within the outer edge of your footwear when fitted properly.

FASTENING & REMOVING: Always put on and remove Hillsound FreeSteps6 while seated. To fasten the FreeSteps6, place toes into the front section of the crampon and adjust so the toe guide wire is sitting in front of the shoe not on top or underneath the shoe. The front four spikes must sit untangled and position well within the outer edge of your footwear underneath the ball of the foot. Pull the rubber back-tab toward the heel and cover your footwear with rubber evenly positioned around the sides of your shoe.

To ensure a snug and secure fit, adjust the positioning of chains and rubber so all spikes sit firmly on the foot. Place one foot at a time to ensure balance and start walking on flat surface to test that it is fitting well. If the chains or rubber are loose, you may need to consider a smaller size for a tighter fit. All shoe makes and brands are different, so the Hillsound sizing chart should be used only as a guide. To remove the product, slide the back-tab off of the heel of the shoe, and slip the front of the foot out of the front section of the crampon.

PROPER APPLICATION: Hillsound's FreeSteps6 are designed for recreational activities such as trail running, ice fishing, light hiking, and are not made for technical climbing. These are not a mountaineering crampon. Avoid using the Hillsound FreeSteps6 on stairs, rocks or river crossings. Only use FreeSteps6 in winter snow and ice conditions. Use the FreeSteps6 with regular outdoor footwear, such as: runners, hiking boots, and insulated boots.

SAFE TRANSPORTATION: Transport the product using a sturdy bag so as to protect the spikes from damaging your valuable belongings. Always position the spikes away from the body when transporting them.

CARE AND MAINTENANCE: After use, the product must be thoroughly cleaned, dried and stored in a cool dry place.